Tsymo Pet Feeder Manual Pdf (2024)

FAQs

How to reset automatic pet feeder? ›

On the front of the Smart Pet Feeder, you will find the 'feed' button. Press the 'feed' button for 5 seconds. When you hear a beep after about 5 seconds, this indicates that the reset has been performed successfully and the Smart Pet Feeder has been reset to factory settings.

Reset the feeder to factory settings, holding down the Add Pet ( ) button for 10 seconds (until the light starts alternating red / green and the lid opens and closes).

To Set Time: 1. After powering feeder, the LCD will show a blinking 12 for time format setup. Use UP or DOWN buttons to scroll to select 12 hour or 24 hour time format. Press RIGHT button to set time.

If the router or internet is not working, try resetting the router or contact your internet provider. Power cycle the feeder by turning off the power switch. Wait 10 seconds and turn the power switch back on. Check for other devices near the feeder that use the internet or other wireless signals (such as a microwave).

Press and hold the Up button and the Down button for three seconds to reset the feeder to factory settings. When the feeder is powered on, press the button once and the feeder will dispense one portion of food.

The MCLR pin can be used to generate a reset. On most PICmicro® devices the MCLR pin is always active.

Can a microchip be removed from a dog? Yes, it is possible to remove a microchip from your pet; however, it is a more difficult and expensive procedure than getting it inserted. This is because removing a microchip requires a full surgical procedure.

If you want to change the ownership information connected to your dog's microchip ID—which is common when new owners adopt a dog that was microchipped by a past owner—you will need to follow a process outlined by the company that issued the microchip.

Change time in increments of 15 minutes each week for four weeks. In week one instead of feeding at 5am/5pm provide a dog treat and go for a walk. Then feed at 5:15. The above chart is an example of how to gradually change your dog's feeding schedule.

This device comprises of a dish with four compartments which opens to feed the pet at a given time, and this is accomplished by a control unit that recognizes the pet that has to be fed. This is done through a sensor placed on the pet collar.

Why is my PetSafe feeder blinking blue? ›

Yellow Blinking Feeder has power and is in setup mode. Yellow Solid Smartphone is connected to the feeder in setup mode. Blue Blinking Slow Feeder is connected to Wi-Fi but no internet. Blue Blinking Fast Feeder is trying to connect to Wi-Fi or is offline.

Invest in an automatic feeder that dispenses pre-measured portions of food at scheduled times. This ensures your dog receives regular meals even when you're not around. Calculate your dog's daily food requirement and divide it into multiple meals.

If you have set up the automatic feeding plan and there is no wifi, the device will prompt you it's offline. In this case, it will still dispense food according to the automatic feeding plan. 5. How to add extra meals for your pets?

THE FUNCTION DESCRIPTION Feed button: Short press to eat one, long press for 5 seconds to restore the factory settings.

How to restart the Fresh Element Mini Pro? Unplug the power cord and plug it in again to restart the device. If there are batteries in the device, remove the battery and reinstall it.

Go the pet feeder' settings page, look for “remove device” Remove it and reset the pet feeder and pair it again through the app.