Understanding Propeller Torque and P-Factor (2024)

This is an attempt to answer the frequent question "Why is my aircraft turning left all the time?".

This occurs only in aircraft with propellers at the front of the aircraft. And yes, it does occur in real life. Four distinct phenomena cause the effect, all causing the aircraft to turn in the same direction. They are:

Contents

  • 1 Prop wash
  • 2 Propeller torque effect
  • 3 P-Factor
  • 4 Gyroscopic Precession
  • 5 External Links

Prop wash

A propeller pushes air not just horizontally to the back, but more in a twisting helix around the fuselage (clockwise as seen from the co*ckpit). As the air whirls around the fuselage it pushes against the left side of the vertical tail (assuming it is located above the propeller's axis), causing the plane to yaw to the left. The prop wash effect is at its greatest when the airflow is flowing more around the fuselage than along it, i.e., at high power and low airspeed, which is the situation when starting the takeoff run.

Propeller torque effect

Torque effect is the influence of engine torque on aircraft movement and control. It is generally exhibited as a left turning tendency in piston single engine propeller driven aircraft.

According to Newton's law, "for every action there is an equal and opposite reaction," such that the propeller, if turning clockwise (when viewed from the co*ckpit), imparts a tendency for the aircraft to rotate counterclockwise. Since most single engine aircraft have propellers rotating clockwise, they rotate to the left, pushing the left wing down.

Typically, the pilot is expected to counter this force through the control inputs. To counter the aircraft roll left, the pilot applies right aileron.

It is important to understand that torque is a movement about the roll axis. Aileron controls roll. Prop torque is not countered by moving the rudder or by setting rudder trim. It is countered by moving or trimming the aileron.

This correction induces adverse yaw, which is corrected by moving or trimming the rudder (right rudder).

On aircraft with contrarotating propellers (propellers that rotate in opposite directions) the torque from the two propellers cancel each other out, so that no compensation is needed.

Further Reading: Propeller Torque Factor

P-Factor

P-factor is the term for asymmetric propeller loading, that causes the airplane to yaw to the left when at high angles of attack.

Assuming a clockwise rotating propeller it is caused by the descending right side of the propeller (as seen from the rear) having a higher angle of attack relative to the oncoming air, and thus generating a higher air flow and thrust than the ascending blade on the left side, which at the other hand will generate less airflow and thrust. This will move the propellers aerodynamic centre to the right of the planes centreline, thus inducing an increasing yaw moment to the left with increasing angle of attack or increasing power. With increasing airspeed and decreasing angle of attack less right rudder will be required to maintain coordinated flight.

This occurs only when the propeller is not meeting the oncoming airflow head-on, for example when an aircraft is moving down the runway at a nose-high attitude (in essence at high angle of attack), as is the case with tail-draggers. Aircraft with tricycle landing gear maintain a level attitude on the takeoff roll run, so there is little P-factor during takeoff roll until lift off.

When having a negative angle of attack the yaw moment will instead be to the right and and left rudder will be required to maintain coordinated flight. However negative angles of attack is rarely encountered in normal flight. In all cases, though, the effect is weaker than prop wash.

Gyroscopic Precession

This is the tendency of a spinning object to precess or move about its axis when disturbed by a force. The engine and propeller act as a big gyroscope. However, gyroscopic precession is likely to be minimal in a typical aircraft.

Gyroscopic precession is frequently confused with p-factor.

One author maintains p-factor is caused by a combination of factors unrelated to gyroscopic precession http://home.earthlink.net/~x-plane/FAQ-Theory-PFactor.html

External Links

  • v
  • t
  • e

Understanding...

Retrieved from ""

Understanding Propeller Torque and P-Factor (2024)

FAQs

What is the difference between P factor and torque? ›

Without the tail rotor, the body of the helicopter would spin opposite to the rotation of the main rotor. The torque of the engine produces a pure rolling moment on the airplane, unlike P-factor, which produces yawing moments.

What is the P factor effect on propellers? ›

P-Factor, which is also called "asymmetric propeller loading", happens when the downward moving propeller blade takes a bigger "bite" of air than the upward moving blade. 2) You're taking off in a tailwheel airplane.

How do you compensate for p factor? ›

Pilots anticipate the need for rudder when changing engine power or pitch angle (angle of attack), and compensate by applying left or right rudder as required.

How to counter prop torque? ›

Prop torque is not countered by moving the rudder or by setting rudder trim. It is countered by moving or trimming the aileron.

Does torque cause yaw or roll? ›

Note, I said rotate the airplane, not turn: Torque is a roll reaction, not a yaw reaction. It tries to rotate the airplane about its longitudinal axis. There is no yaw involved.

What factor will increase propeller slip? ›

But in water, a propeller will always slip .. and the more 'pushing' work it has to do, the more slip, so when the boat is tied to a bollard or is very heavily loaded and restrained, its Slip is greatest. Thrust is the force of water coming from the propeller slipstream.

What are the 4 propeller effects? ›

We'll go over each of these in some more detail, but the four that we're going to focus on are torque, spiraling slipstream, precession, and what most people call P-factor (asymmetric thrust).

What is the propeller torque effect? ›

To a pilot, torque is the force that causes an opposite rotation. As the propeller spins clockwise (as viewed from the pilot seat), the airplane experiences a rotating force in the opposite direction. In this case, that means the airplane wants to roll left, an effect that is damped by the wings.

Why is the P-factor important? ›

The p-factor is a construct that is thought to explain and maybe even cause variation in all forms of psychopathology. Since its 'discovery' in 2012, hundreds of studies have been dedicated to the extraction and validation of statistical instantiations of the p-factor, called general factors of psychopathology.

Why does a descending propeller blade produce more thrust? ›

Additionally, the blade that goes down will do so at an increased AoA to the relative airflow and in the opposite direction the AoA will be reduced. The combined effect of these is that the blade moving down would create more lift (which, in this case is thrust) and the one moving up would create less.

What is the P-factor during takeoff? ›

P-Factor phenomenon occurs when the descending blade takes in more load than the upgoing blade. It can happen in two scenarios: The aircraft is taking off or in slow flight, where the AOA (angle of attack) is higher.

What is the torque reaction of a propeller? ›

In a single-propeller plane, the torque effect causes the plane to turn upwards and left in response to the propeller turning the plane in the opposite direction of the propeller's clockwise spin.

What is the formula for propeller torque? ›

To calculate the propeller torque, divide the propeller horsepower by the propeller speed, then multiply by 5252.

What is the p factor caused by? ›

P-factor is due to the ANGLE of ATTACK of the propeller, or in other words, the angle at which the air meets the propeller. The propeller takes a bigger “bite” of air on the right side producing more thrust from the right half of the propeller thus trying to turn the airplane left.

What is the difference between torque and PS? ›

Power defines the rate of work done while torque is the energy that is applied while rotating an object about an axis or pivot point. Torque and power may seem like difficult concepts to understand, but on the contrary, they are interesting, and we apply them in our day-to-day life.

What is the torque on a helicopter? ›

With a single main rotor helicopter, a torque effect is created as the engine turns the rotor. This torque causes the body of the helicopter to turn in the opposite direction of the rotor (Newton's Third Law: Every action has an equal and opposite reaction, as explained in Chapter 2, Aerodynamics of Flight).

How do you calculate torque factor? ›

Formula for Torque: The formula for calculating torque is τ = | r | | F | sin ⁡ , where is the magnitude of the lever arm, is the magnitude of the force vector, and is the angle formed between the force and lever arm vectors.

What is the torque in an airplane? ›

In aviation, torque comes into play in propeller-driven airplanes. The engine's output force (torque) turns the airplane propeller, which generates thrust. However, this also creates a reactive force known as the torque effect, causing the airplane to rotate in the opposite direction of the propeller.

Top Articles
Latest Posts
Article information

Author: Virgilio Hermann JD

Last Updated:

Views: 6304

Rating: 4 / 5 (41 voted)

Reviews: 80% of readers found this page helpful

Author information

Name: Virgilio Hermann JD

Birthday: 1997-12-21

Address: 6946 Schoen Cove, Sipesshire, MO 55944

Phone: +3763365785260

Job: Accounting Engineer

Hobby: Web surfing, Rafting, Dowsing, Stand-up comedy, Ghost hunting, Swimming, Amateur radio

Introduction: My name is Virgilio Hermann JD, I am a fine, gifted, beautiful, encouraging, kind, talented, zealous person who loves writing and wants to share my knowledge and understanding with you.